For more on the classifications, click here.Unfortunately, if left clogged, lint and dirt trapped by the water pump could get on your clothes. We Have only scratched the surface on the types of toploaders out there. Just keep in mind that removing the card from the case without any damage should be possible. It shouldn’t be “jammed” in the case, but make sure it is snug and not sliding around. Just make sure there is a little room above the card. These are usually cleat, glove, helmet, or ball cards that you cannot protect with a standard toploader (even the thick ones).įor these, you can use snap shut or slide cases that are meant to hold up to 50 cards at once (1500 mm or more). Not many products have cards that go beyond 180 point stock, but occasionally you will come across some ultra-thick cards that are hard to protect.
Top loader Patch#
Use these toploaders for the super thick patch and memorabilia hits, including those high-end rookie patch autos you’ll find in products like: The thickest card stock out there can usually be protected with 180 point top loaders, though there are some exceptions. The thickest card stock out there can usually be protected with 180 point toploaders, though there are some exceptions. Protecting Your Cards With 180 point toploaders Use 130 point toploaders for cards in products like: Note that for 130 point top loaders and higher, you will also need thick penny sleeves. You should follow the same advice with base cards and hits. Most mid-end or high-end products will have thick base stock and will need toploaders at least 130 points or higher. Protecting Your Cards With 130 Point Toploaders You can order your 100 point toploaders from here.